講演名 2011-03-04
穿刺型超音波顕微鏡用振動走査法による生体計測(卒論・修論特集(ショートノート))
木屋 雅之, 柄澤 浩一, 吉澤 昌純, 入江 喬介, 守屋 正, 伊東 紘一,
PDFダウンロードページ PDFダウンロードページへ
抄録(和) 細径石英棒を用いた穿刺型超音波顕微鏡用の走査法の改善のために,オーディオスピーカを用いて,従来よりも安価で速い走査法を開発した.走査の基本原理はテコ(石英棒)の終端の動きに基づいて行われる.オーディオスピーカにより,テコの一端(圧電素子側)を振動させることで,もう一端(超音波送受信側)が振動する.この振動中の任意の点において,超音波を送受信し,その位置の測定を行う.今回,筋肉層と脂肪層の音響インピーダンス差分画像を得ることで振動走査法の有効性が確認できた.実験結果より,振動走査法が穿刺型超音波顕微鏡の実現に役立つことを確認した.
抄録(英) For realization of low-cost, faster scanning rate, and improvement of scanning resolution of puncture needle-type ultrasonography using a fused quartz rod, we developed the scanning method using the audio speaker. The principle of the scanning method is based on the movements of the end point of a lever. When the end point (transducer side) is vibrated by the audio speaker, the other point (sensing side) is also vibrated. When the endpoint of the lever is at a point during the vibration, an ultrasonic signal is transmitted and received, and the measurement of the point is conducted. We confirmed the effectiveness of the vibration scanning method by imaging the acoustic impedance difference of the muscle and fat sample. The experimental results show that the scanning method is useful for puncture needle-type ultrasonography.
キーワード(和) 超音波干渉法 / 音響インピーダンス差分イメージング法 / 等価サンプリング
キーワード(英) ultrasonic interference method / imaging method for acoustic impedance difference / equivalent-time sampling
資料番号 EMD2010-161
発行日

研究会情報
研究会 EMD
開催期間 2011/2/25(から1日開催)
開催地(和)
開催地(英)
テーマ(和)
テーマ(英)
委員長氏名(和)
委員長氏名(英)
副委員長氏名(和)
副委員長氏名(英)
幹事氏名(和)
幹事氏名(英)
幹事補佐氏名(和)
幹事補佐氏名(英)

講演論文情報詳細
申込み研究会 Electromechanical Devices (EMD)
本文の言語 JPN
タイトル(和) 穿刺型超音波顕微鏡用振動走査法による生体計測(卒論・修論特集(ショートノート))
サブタイトル(和)
タイトル(英) In Vitro Measurement by Vibration Scanning Method for Puncture Needle-Type Ultrasonography
サブタイトル(和)
キーワード(1)(和/英) 超音波干渉法 / ultrasonic interference method
キーワード(2)(和/英) 音響インピーダンス差分イメージング法 / imaging method for acoustic impedance difference
キーワード(3)(和/英) 等価サンプリング / equivalent-time sampling
第 1 著者 氏名(和/英) 木屋 雅之 / Masayuki Kiya
第 1 著者 所属(和/英) 都立産業技術高等専門学校
Graduate School of System Design, Tokyo Metropolitan University
第 2 著者 氏名(和/英) 柄澤 浩一 / Kouichi Karasawa
第 2 著者 所属(和/英) 都立産業技術高等専門学校
Graduate School of System Design, Tokyo Metropolitan University
第 3 著者 氏名(和/英) 吉澤 昌純 / Masasumi Yoshizawa
第 3 著者 所属(和/英) 都立産業技術高等専門学校
Graduate School of System Design, Tokyo Metropolitan University
第 4 著者 氏名(和/英) 入江 喬介 / Takasuke Irie
第 4 著者 所属(和/英) マイクロソニック株式会社
Microsonic Co., Ltd.
第 5 著者 氏名(和/英) 守屋 正 / Tadashi Moriya
第 5 著者 所属(和/英) 首都大学東京
Department of Electrical Engineering, Tokyo Metropolitan University
第 6 著者 氏名(和/英) 伊東 紘一 / Kouichi Itoh
第 6 著者 所属(和/英) 常陸大宮済生会病院
Hitachi-Omiya Saiseikai Hospital
発表年月日 2011-03-04
資料番号 EMD2010-161
巻番号(vol) vol.110
号番号(no) 451
ページ範囲 pp.-
ページ数 4
発行日