講演名 2003/6/23
Fabrication of low loss transmission line with Surface micromachining technology (AWAD2003 (Asia-Pacific Workshop on Fundamental and Application of Advanced Semiconductor Devices))
,
PDFダウンロードページ PDFダウンロードページへ
抄録(和)
抄録(英) In this paper, we fabricated the low-loss transmission line of air-bridge form using the surface micromachining (SMM). Proposed structure used the polyimide dielectric posts between the signal line and ground to obtain the low-loss and the wide characteristic impedance range in millimeter waves. The whole length of fabricated transmission line is 2 mm, and post size is 10 × 10 μm^2, and we fabricated the signal line with 7 μm and 10 μm height to compare the characteristics by signal line height change from substrate. From the fabricated DAML's results of measurements, we obtained 2.2 dB/cm attenuation in the 7 μm height DAML and 1.5 dB/cm attenuation in the 10 μm height DAML up to 50 GHz. Then the change of characteristic impedance showed 100-20 ohms, 115-27 ohm, respectively.
キーワード(和)
キーワード(英) Surface micromachining / Microstrip line / air-bridge
資料番号 ED2003-66,SDM2003-77
発行日

研究会情報
研究会 ED
開催期間 2003/6/23(から1日開催)
開催地(和)
開催地(英)
テーマ(和)
テーマ(英)
委員長氏名(和)
委員長氏名(英)
副委員長氏名(和)
副委員長氏名(英)
幹事氏名(和)
幹事氏名(英)
幹事補佐氏名(和)
幹事補佐氏名(英)

講演論文情報詳細
申込み研究会 Electron Devices (ED)
本文の言語 ENG
タイトル(和)
サブタイトル(和)
タイトル(英) Fabrication of low loss transmission line with Surface micromachining technology (AWAD2003 (Asia-Pacific Workshop on Fundamental and Application of Advanced Semiconductor Devices))
サブタイトル(和)
キーワード(1)(和/英) / Surface micromachining
第 1 著者 氏名(和/英) / Han-Shin Lee
第 1 著者 所属(和/英)
Millimeter-wave INnovation Technology research center (MINT), Dongguk University
発表年月日 2003/6/23
資料番号 ED2003-66,SDM2003-77
巻番号(vol) vol.103
号番号(no) 159
ページ範囲 pp.-
ページ数 5
発行日