講演名 2018-11-16
抵抗を装荷したヘアピン形共振器を用いたBPFによる通過帯域の平坦化
筑紫 友洋(電通大), 小野 哲(電通大), 和田 光司(電通大),
PDFダウンロードページ PDFダウンロードページへ
抄録(和) 本研究では,初めにマイクロストリップ線路構造による共振器に抵抗素子を装荷することによって,共振器の無負荷Q値が制御可能なヘアピン形シングルモード共振器を提案する.抵抗の装荷位置によって共振器の無負荷Q値が制御可能となることを,計算式及び電磁界シミュレーションを用いて示す.共振器に装荷するチップ抵抗素子の数GHz帯での等価回路モデルは一般公開されていないため,抵抗素子を実際に測定することでチップ抵抗素子の等価回路モデルを作成した.今回の主目的であるバンドパスフィルタ(BPF)の通過帯域の平坦化のために,共振器の無負荷Q値の制御に加え,BPF内の電磁界結合を考慮しつつ異なる無負荷Q 値の共振器を並列に結合させることで,減衰極による優れた遮断特性及び平坦な通過帯域を有する4段バンドパスフィルタ(BPF)を構成する.今回の設計手順としては,まず提案するヘアピン形共振器及びオープンループ形共振器をそれぞれ用いて,結合行列より算出した各パラメータを満たすようにそれぞれで回路構造を構成する.そして,通過帯域が平坦となるように,それぞれの構成した回路を接続する線路を回路シミュレータを用いて構成する.最後に,フィルタの回路構造を電磁界シミュレーションを用いて構成し,解析によって特性を確認した.
抄録(英) In this study, firstly, the single mode resistor loaded hairpin shaped resonator is proposed. It is shown using some equations and electromagnetic (EM) simulation that unloaded quality factor can be controlled by setting position of resistor. Secondary, an equivalent circuit of a chip resistor is estimated using measured reflection characteristics of a chip resistor. Furthermore, a fourth order bandpass filter (BPF) having good frequency selectivity caused by attenuation poles and a flat passband is constructed by parallel coupling resonators of different values of unloaded quality factors. In this design procedure, the fourth order BPF is divided to two sections which mean a second order BPF with higher unloaded quality factors and that with lower unloaded quality factors. The second order BPF with higher quality factor is constructed using opened loop shaped resonators. Other BPF with lower quality factor is constructed using resistor loaded hairpin shaped resonators. The design parameters as external quality factors, coupling coefficients, resonant frequencies and unloaded quality factors are calculated using coupling matrix. Also, input/output (I/O) transmission lines between two types of BPF structures are configured. Finally, the circuit structure of the fourth order BPF included I/O transmission lines is configured using EM simulator. It is good agreement with design specification. Sharp frequency selectivity and flat passband characteristics of fourth order BPF are realized.
キーワード(和) 抵抗装荷ヘアピン形共振器 / オープンループ形共振器 / 帯域通過フィルタ / 周波数選択性 / 通過帯域平坦特性 / チップ抵抗素子 / 結合行列
キーワード(英) Resistor loaded hairpin shaped resonator / Opened loop resonator / Bandpass filter (BPF) / Frequency selectivity / Flat passband characteristics / Chip resistor / Coupling matrix
資料番号 MW2018-109
発行日 2018-11-08 (MW)

研究会情報
研究会 MW
開催期間 2018/11/15(から2日開催)
開催地(和) 福江文化会館
開催地(英) Fukue Cultural Hall
テーマ(和) マイクロ波/一般
テーマ(英) Microwave Technologies
委員長氏名(和) 村口 正弘(東京理科大)
委員長氏名(英) Masahiro Muraguchi(TUS)
副委員長氏名(和) 古神 義則(宇都宮大) / 岡崎 浩司(NTTドコモ) / 田島 賢一(三菱電機)
副委員長氏名(英) Yoshinori Kogami(Utsunomiya Univ.) / Hiroshi Okazaki(NTT DOCOMO) / Kenichi Tajima(Mitsubishi Electric)
幹事氏名(和) 中村 宝弘(日立) / 清水 隆志(宇都宮大)
幹事氏名(英) Takahiro Nakamura(HITACHI) / Takashi Shimizu(Utsunomiya Univ.)
幹事補佐氏名(和) 本良 瑞樹(東北大) / 吉田 賢史(鹿児島大)
幹事補佐氏名(英) Mizuki Motoyoshi(Tohoku Univ.) / Satoshi Yoshida(Kagoshima Univ.)

講演論文情報詳細
申込み研究会 Technical Committee on Microwaves
本文の言語 JPN
タイトル(和) 抵抗を装荷したヘアピン形共振器を用いたBPFによる通過帯域の平坦化
サブタイトル(和)
タイトル(英) Realization of Flat Passband Characteristics for BPF Using Resistor Loaded Hairpin Shaped Resonators
サブタイトル(和)
キーワード(1)(和/英) 抵抗装荷ヘアピン形共振器 / Resistor loaded hairpin shaped resonator
キーワード(2)(和/英) オープンループ形共振器 / Opened loop resonator
キーワード(3)(和/英) 帯域通過フィルタ / Bandpass filter (BPF)
キーワード(4)(和/英) 周波数選択性 / Frequency selectivity
キーワード(5)(和/英) 通過帯域平坦特性 / Flat passband characteristics
キーワード(6)(和/英) チップ抵抗素子 / Chip resistor
キーワード(7)(和/英) 結合行列 / Coupling matrix
第 1 著者 氏名(和/英) 筑紫 友洋 / Tomohiro Tsukushi
第 1 著者 所属(和/英) 電気通信大学(略称:電通大)
University of Electro-Communications(略称:UEC)
第 2 著者 氏名(和/英) 小野 哲 / Satoshi Ono
第 2 著者 所属(和/英) 電気通信大学(略称:電通大)
University of Electro-Communications(略称:UEC)
第 3 著者 氏名(和/英) 和田 光司 / Koji Wada
第 3 著者 所属(和/英) 電気通信大学(略称:電通大)
University of Electro-Communications(略称:UEC)
発表年月日 2018-11-16
資料番号 MW2018-109
巻番号(vol) vol.118
号番号(no) MW-308
ページ範囲 pp.89-94(MW),
ページ数 6
発行日 2018-11-08 (MW)