講演名 | 2021-10-27 K0.4Na0.6NbO3とK0.5Na0.5NbO3の混合粉末から作製したK0.45Na0.55NbO3セラミックスの特性 斉京 朋輝(信州大), 小林 稜(信州大), 番場 教子(信州大), |
---|---|
PDFダウンロードページ | PDFダウンロードページへ |
抄録(和) | 本研究では多くの固溶体の母材であるK0.45Na0.55NbO3の特性向上につながる圧電定数d33の粒径依存性を明らかにすることを目的に,K0.5Na0.5NbO3とK0.4Na0.6NbO3の混合粉末及び,K0.45Na0.55NbO3単相粉末を二段階焼成し,平均粒径が約2?mから5.5?mのセラミックスを作製した。単相と混合粉末では焼結性が異なり,単相粉末に比べ混合粉末から作製したセラミックスで粒成長が進むことが確認された。単相,混合粉末を同条件で焼成した場合,キュリー点TCに大きな差はなかったが,高温での加熱時間が長くなるとどちらの粉末でもTCが低下する傾向が見られた。また得られた圧電定数d33の粒径依存性からK0.45Na0.55NbO3の最適粒径は2~3?mの間にあると推測される。今回,混合粉末から作製した平均粒径が約2.4?m のK0.45Na0.55NbO3セラミックスで最も高いd33=126pC/N が得られた。 |
抄録(英) | In order to improve the piezoelectric constant, d33, of K0.45Na0.55NbO3 ceramics, which is a typical base material composition of potassium sodium niobate solid solution, the grain size dependence of d33 was investigated in this study. Two kinds of powders were used for two-step sintering to produce ceramics of varying average grain size: a mixed powder of K0.4Na0.6NbO3 and K0.5Na0.5NbO3 and a single-phase K0.45Na0.55NbO3 powder. As a result, ceramics with average grain size of about 2?m to 5.5?m were obtained. It was confirmed that the single-phase powder and the mixed powder had different sinterability, and that the mixed powder promoted diffusion more than the single-phase powder. When the single-phase powder and the mixed powder were sintered under the same conditions, there was no significant difference in the Curie temperature, TC. However, the TC decreased in both powders with increasing heating time at high temperatures. The grain size dependence of d33 was obtained, and the optimum average grain size of K0.45Na0.55NbO3 ceramic was estimated within about 2 to 3 ?m. The maximum d33 value in this study was 126 pC/N for ceramics with an average grain size of approximately 2.4 ?m fabricated from the mixed powder. |
キーワード(和) | ニオブ酸カリウムナトリウムセラミックス / K0.45Na0.55NbO3 / 混合粉末 / 圧電定数d33 / 粒径 |
キーワード(英) | Potassium sodium niobate ceramics / K0.45Na0.55NbO3 / Mixed powder / Piezoelectric constant d33 / Grain size |
資料番号 | CPM2021-33 |
発行日 | 2021-10-20 (CPM) |
研究会情報 | |
研究会 | CPM |
---|---|
開催期間 | 2021/10/27(から1日開催) |
開催地(和) | オンライン開催 |
開催地(英) | Online |
テーマ(和) | 機能性材料(半導体、磁性体、誘電体、透明導電体・半導体、等)薄膜プロセス/材料/デバイス,一般 |
テーマ(英) | Functional materials (semiconductors, magnetic materials, dielectrics, transparent conductors / semiconductors, etc.) thin film processes / materials / devices, etc. |
委員長氏名(和) | 中村 雄一(豊橋技科大) |
委員長氏名(英) | Yuichi Nakamura(Toyohashi Univ. of Tech.) |
副委員長氏名(和) | 中澤 日出樹(弘前大) |
副委員長氏名(英) | Hideki Nakazawa(Hirosaki Univ.) |
幹事氏名(和) | 寺迫 智昭(愛媛大) / 武山 真弓(北見工大) |
幹事氏名(英) | Tomoaki Terasako(Ehime Univ.) / Mayumi Takeyama(Kitami Inst. of Tech) |
幹事補佐氏名(和) | 木村 康男(東京工科大) / 廣瀬 文彦(山形大) / 番場 教子(信州大) |
幹事補佐氏名(英) | Yasuo Kimura(Tokyo Univ. of Tech.) / Fumihiko Hirose(Yamagata Univ.) / Noriko Bamba(Shinshu Univ.) |
講演論文情報詳細 | |
申込み研究会 | Technical Committee on Component Parts and Materials |
---|---|
本文の言語 | JPN |
タイトル(和) | K0.4Na0.6NbO3とK0.5Na0.5NbO3の混合粉末から作製したK0.45Na0.55NbO3セラミックスの特性 |
サブタイトル(和) | |
タイトル(英) | Characteristics of K0.45Na0.55NbO3 ceramics fabricated from a mixed powder of K0.4Na0.6NbO3 and K0.5Na0.5NbO3 |
サブタイトル(和) | |
キーワード(1)(和/英) | ニオブ酸カリウムナトリウムセラミックス / Potassium sodium niobate ceramics |
キーワード(2)(和/英) | K0.45Na0.55NbO3 / K0.45Na0.55NbO3 |
キーワード(3)(和/英) | 混合粉末 / Mixed powder |
キーワード(4)(和/英) | 圧電定数d33 / Piezoelectric constant d33 |
キーワード(5)(和/英) | 粒径 / Grain size |
第 1 著者 氏名(和/英) | 斉京 朋輝 / Tomoki Saikyo |
第 1 著者 所属(和/英) | 信州大学(略称:信州大) Shinshu University(略称:Shinshu Univ.) |
第 2 著者 氏名(和/英) | 小林 稜 / Ryo Kobayashi |
第 2 著者 所属(和/英) | 信州大学(略称:信州大) Shinshu University(略称:Shinshu Univ.) |
第 3 著者 氏名(和/英) | 番場 教子 / Noriko Bamba |
第 3 著者 所属(和/英) | 信州大学(略称:信州大) Shinshu University(略称:Shinshu Univ.) |
発表年月日 | 2021-10-27 |
資料番号 | CPM2021-33 |
巻番号(vol) | vol.121 |
号番号(no) | CPM-220 |
ページ範囲 | pp.51-56(CPM), |
ページ数 | 6 |
発行日 | 2021-10-20 (CPM) |