講演抄録/キーワード |
講演名 |
2022-04-15 13:55
クレーンワイヤーによる大電力伝送システム ○吉井達也・都築伸二・杉本大志(愛媛大)・岡南佑紀(三菱電機) EMCJ2022-3 |
抄録 |
(和) |
筆者らは,クレーンのフック部分に取り付けた通信機に対して常時給電しながらブーム先端と通信するために,クレーンワイヤーを100W 程度の大電力伝送路かつ通信路として利用する方法について研究している.従来システムでは最大1W 程度しかフックで受電できなかったが,本稿では,送電側にパワーアンプを挿入し,また受電側に力率改善コンデンサを挿入した結果,ワイヤー長30m において最大72.8W まで受電可能になったことを述べている.また,この大電力伝送に伴う高調波ノイズが同じワイヤーで行っている通信に及ぼす影響について考察している. |
(英) |
The authors have studied a crane wire system to transmit about 100 W of power and communication signals from the boom of a crane to the hook, and to provide constant power to the equipment attached to the hook. While our conventional systems could only receive at most 1 W of power at the hook, a method of inserting a power amplifier on the transmitter side
and a power factor correction capacitor on the receiver side is proposed in this paper to enable the system to receive up to 72.8 W of power. The impact of the noise generated by the proposing high-power-transmission system on communications over the same wire is also discussed. |
キーワード |
(和) |
クレーンワイヤー / 電力伝送 / G3-PLC / 磁気飽和 / 高調波ノイズ / / / |
(英) |
Crane Wire / Power Transmission / G3-PLC / Magnetic saturation, / Harmonic noise / / / |
文献情報 |
信学技報, vol. 122, no. 4, EMCJ2022-3, pp. 13-18, 2022年4月. |
資料番号 |
EMCJ2022-3 |
発行日 |
2022-04-08 (EMCJ) |
ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMCJ2022-3 |