講演抄録/キーワード |
講演名 |
2022-04-15 16:05
[招待講演]マイクロ波パワーアンプ用動的出力整合回路の基礎検討 ○石崎俊雄(龍谷大) WPT2022-12 MW2022-12 エレソ技報アーカイブへのリンク:MW2022-12 |
抄録 |
(和) |
パワーアンプをマイクロ波加熱で使用する際,負荷インピーダンス変動で出力電力や効率が低下する.マイクロ波を適切に照射し続けるには動的な負荷インピーダンス整合が必要である.整合回路は,スミスチャート上の広範囲でインピーダンス整合でき,回路損失が小さいことが要求される.3個の容量を用いたFETスイッチ式可変整合回路では,回路方程式から各容量値の厳密解を求め,FETスイッチ回路をオフ容量込みで設計した.周波数掃引方式では,インピーダンス軌跡がスミスチャート上を満遍なく覆う特性を有する4段構成の誘電体同軸共振器を用いた小型・低損失な可変整合回路を考案した.いずれの回路もシミュレーションで良好な整合が確認できた. |
(英) |
When using a power amplifier for microwave heating, the output power and efficiency decrease due to load impedance fluctuations. Dynamic load impedance matching is required to continue to irradiate microwaves properly. The matching circuit is required to be able to match impedance over a wide range on the Smith chart and to have a small circuit loss. In the FET-switch-type variable matching circuit using three capacitances, the exact solution of each capacitance value was obtained from the circuit equation, and the FET switch circuit was designed including the OFF-capacitance. In the frequency-sweep-type circuit, the author devised a compact, low-loss variable matching circuit using a four-stage dielectric coaxial resonator that has the characteristic that the impedance locus covers almost of the whole Smith chart area. Good matching was confirmed by simulation in each circuit. |
キーワード |
(和) |
パワーアンプ / 負荷インピーダンス / 動的整合 / インピーダンス可変方式 / 周波数掃引方式 / / / |
(英) |
Power amplifier / Load impedance / Dynamic matching / Variable-impedance-type / Frequency-sweep-type / / / |
文献情報 |
信学技報, vol. 122, no. 2, MW2022-12, pp. 46-51, 2022年4月. |
資料番号 |
MW2022-12 |
発行日 |
2022-04-08 (WPT, MW) |
ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
WPT2022-12 MW2022-12 エレソ技報アーカイブへのリンク:MW2022-12 |