講演抄録/キーワード |
講演名 |
2022-02-10 15:35
電気接点間に吹き付ける空気の流速と開離時アークに対するその影響の数値計算による検討 ○奥野貴成・関川純哉(静岡大) R2021-45 EMD2021-13 エレソ技報アーカイブへのリンク:EMD2021-13 |
抄録 |
(和) |
直流高電圧回路の遮断において,接点開離時に発生する開離時アークはできる限り短い時間での消弧が望まれる.そこで電気接点対に横から空気を吹き付けることにより開離時アークの継続時間が短縮された.その際の電気接点間隙における開離時アークの位置解析及び流速の数値計算を行った.その結果, 接点間隙に横から空気を吹き付けた場合,開離時アークの下流端が接点中心から風下側1mmに到達する時間は吹き付けの流量が大きくなるほど短くなるが,時間の短縮幅は小さくなった.開離時アークの下流端の位置が接点中心から風下側1mm時のアーク中心の流速は吹き付ける流量が大きいほど,大きくなっていた.各流量に対して接点中心とそこから下方に1mmの位置での流速を比較すると,どの流量の場合も接点中心における流速の方が大きく,流量が大きい程,流速は大きくなっていた. |
(英) |
In the interruption of DC high voltage circuits, it is desirable to extinguish the arc at the opening of the contacts in as short a time as possible. In this study, the duration of the opening arc was shortened by blowing air across the electrical contact pair. The position of the opening arc in the gap between the electrical contacts and the velocity of the flow were analyzed numerically. As a result, when air is blown into the contact gap from the side, the time required for the lower edge of the opening arc to reach 1 mm downwind from the center of the contact becomes shorter as the flow rate of the air blowing increases, but the range of the time reduction becomes smaller. The velocity at the center of the arc when the lower end of the arc was 1 mm downwind from the center of the contact increased with the flow rate. Comparing the velocities at the center of the contact point and at 1 mm downwind from the center of the contact point for each flow rate, the velocity at the center of the contact point was larger for all flow rates. |
キーワード |
(和) |
直流高電圧回路 / 開離時アーク / 空気吹き付け / 数値計算 / / / / |
(英) |
DC circuit / Break arc / Air blowing / Numerical calculation / / / / |
文献情報 |
信学技報, vol. 121, no. 369, EMD2021-13, pp. 12-17, 2022年2月. |
資料番号 |
EMD2021-13 |
発行日 |
2022-02-03 (R, EMD) |
ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
R2021-45 EMD2021-13 エレソ技報アーカイブへのリンク:EMD2021-13 |