講演抄録/キーワード |
講演名 |
2019-10-24 11:15
2本の分岐端子を短絡端に対し45度傾けて接続したT分岐形OMT ○湯川秀憲・牛嶋 優・高橋 徹・米田尚史・宮崎守泰(三菱電機) EMCJ2019-41 MW2019-70 EST2019-49 エレソ技報アーカイブへのリンク:MW2019-70 EST2019-49 |
抄録 |
(和) |
同一の周波数帯の直交するふたつの偏波を分離する偏波分離回路のひとつとしてT分岐形OMT(Ortho-Mode-Transducer)が知られている。2本の分岐端子を短絡端近傍に「T分岐」状に配置することで軸長を短くできる利点があるが、偏波を分離するためには各分岐端子の広壁面の向きは直交させる必要がある。このため、各分岐端子の周波数特性は異なるものとなり、広帯域化が難しいという問題があった。ここでは、本問題を解決するため、2本の分岐端子を短絡端に対し45度傾けて接続したT分岐形OMTを考案し、金属3Dプリンタによる試作評価を行ったので報告する。 |
(英) |
A T-junction OMT (Ortho-Mode-Transducer) is well known as one of waveguide components that separate two orthogonal linear polarizations in the same frequency band. It is formed by a short circuited common circular waveguide section exhibiting two rectangular waveguide ports at the short circuit situated at opposed side walls. One of the advantages of the T-junction OMT is short axial length. However, for its asymmetry, it is difficult to realize the wideband performances.We propose a symmetrical T-junction OMT to realize the wideband performances. The proposed configuration has two waveguides which are 45-degree tilted to the short circuit. We fabricated a proposed T-junction OMT in a single piece of an aluminum alloy, using a commercial metal 3D-printer. The measurement results were in agreement with the calculated results well, and the validity of the proposed OMT was confirmed. |
キーワード |
(和) |
アンテナ給電回路 / 導波管 / 偏波分離回路 / 3Dプリンタ / / / / |
(英) |
Antenna feed systems / Waveguide / OMT / 3D-printer / / / / |
文献情報 |
信学技報, vol. 119, no. 242, MW2019-70, pp. 27-32, 2019年10月. |
資料番号 |
MW2019-70 |
発行日 |
2019-10-17 (EMCJ, MW, EST) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMCJ2019-41 MW2019-70 EST2019-49 エレソ技報アーカイブへのリンク:MW2019-70 EST2019-49 |
|