講演抄録/キーワード |
講演名 |
2016-05-19 15:00
モード変換器を用いた多電力分配器のアイソレーション特性の改善 ○三木敬太・岸原充佳・大久保賢祐・滝本裕則(岡山県立大)・太田 勲(兵庫県立大) MW2016-9 エレソ技報アーカイブへのリンク:MW2016-9 |
抄録 |
(和) |
単一モード導波管(SMWG)と多モード導波管 (OMWG)を直線的に配置したTE10-TEp0モード変換器が報告されている.そこでは, OMWG 内に垂直に複数の金属ポストを装荷し, その径と位置を最適化することによって反射損と不要モード抑圧が20dB以上となる比帯域幅が10%前後のモード変換器を実現している. この構造を用いればTE10モードの多電力分配器が得られるが, 出力ポート間のアイソレーション特性が十分ではない. 本研究では, 多モード導波管部に抵抗板を装荷することにより, 多電力分配器のアイソレーション特性改善を試みている. 装荷する抵抗板の寸法を調整することで, 帯域内で20dB程度のアイソレーション特性が得られることを示している. |
(英) |
The TE10-TEp0 mode transducers consisting of a linearly arranged single-mode waveguide(SMWG) and an over-moded waveguide(OMWG) have been reported. By inserting metallic posts in the OMWG and optimizing their radii and positions, the mode transducers with fractional bandwidth of about 10% under the mode suppression better than 20dB have been realized. However, the multi-way TE10 mode power divider based on the present mode transducers results in poor isolation characteristics. In this paper, an improvement of the isolation characteristics is attempted by inserting the resistive sheets in the OMWG. After adjusting achieved and the dimensions of the resistive sheets, it is shown that the isolation characteristics of about 20dB are achieved. |
キーワード |
(和) |
マイクロ波 / 導波管 / モード変換器 / 電力分配器 / / / / |
(英) |
Microwave / Waveguide / Mode transducer / Power divider / / / / |
文献情報 |
信学技報, vol. 116, no. 51, MW2016-9, pp. 1-6, 2016年5月. |
資料番号 |
MW2016-9 |
発行日 |
2016-05-12 (MW) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
MW2016-9 エレソ技報アーカイブへのリンク:MW2016-9 |