講演抄録/キーワード |
講演名 |
2016-01-19 13:45
近赤外線カメラを用いた3Dプリンター用デジタルデータ著作権保護技術 ○鈴木雅洋・ピヤラット シラパスパコォンウォン(神奈川工科大)・高嶋洋一(NTT)・鳥井秀幸・海野 浩・上平員丈(神奈川工科大) EMM2015-73 |
抄録 |
(和) |
筆者らが提案した3Dプリンター用デジタルデータの著作権保護技術について,近赤外線カメラを用いた情報の読み出しを評価した.本技術は,造形物を造形する際に,造形物の内部に外部から見えないように著作権情報を埋め込み,不正が疑われる造形物があれば,埋め込まれた情報を造形物から読み出して,不正な造形物か否かを確認する.本研究では,3Dプリンターによって低密度で造形物を造形して,造形物内部に微小な高密度領域を多数形成して,この微小領域の配置形態により情報を表現するようにした.840 nmの近赤外線を用いて,InGaAs赤外線カメラで撮像した造形物の透過像から,透過像において微小領域の存在を確認できて,埋め込まれた情報の読み出しが可能であることがわかった.本方法の実現性を確認した. |
(英) |
We evaluated our previously proposed technique for protecting copyrights of digital data for 3-D printing. The proposed technique embedded copyright information into not only digital data but also fabricated objects and read it out from the objects to confirm illegal acts such as bootleg products. In this study, copyright information was embedded into low infill density objects by constructing their inside with small high infill density areas, and a near-infrared camera was used for readout. The results obtained from the experiment indicated that the high infill density areas inside low infill density objects could be recognized from near-infrared images. We demonstrated that the proposed technique was applicable to the methods using near-infrared cameras for reading our copyright information embedded inside fabricated objects. |
キーワード |
(和) |
デジタルファブリケーション / 三次元印刷 / 3Dプリンター / 著作権 / / / / |
(英) |
Digital Fabrication / 3-D Printing / 3-D Printer / Copyright / / / / |
文献情報 |
信学技報, vol. 115, no. 397, EMM2015-73, pp. 71-74, 2016年1月. |
資料番号 |
EMM2015-73 |
発行日 |
2016-01-11 (EMM) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMM2015-73 |