講演抄録/キーワード |
講演名 |
2014-08-28 09:30
3Dプリンターによるホーンアンテナの試作とその評価 ○小林弘一・川村龍一(阪工大)・山田寛喜(新潟大) AP2014-72 |
抄録 |
(和) |
近年、急速に注目を集めている3Dプリンターを用いて、角錐ホーン、リッジ付角錐ホーン、コルゲート円錐ホーンなどの小型の開口面アンテナを製作し、その放射特性を計測した結果を報告する。開口面法あるいは数値解法により、これらのアンテナを設計し、その寸法データを3Dプリンターに入力して樹脂の積層で製作する。その後、樹脂表面を導電塗料でコーティングし、入力インピーダンスと放射パターン等を測定し、理論値と比較する。導電塗料の反射率は、同一樹脂の平板にこれを塗布し導波管端に装着して反射損失を計測し、問題がないことを確認する。製作した樹脂アンテナの性能は従来の方法によるものと比べて大きな遜色はなく、短時間で安価に性能評価できることを実証する。 |
(英) |
Using 3D printer rapidly attracting our attention in the last few years, we fabricate small aperture horn antenna such as pyramidal horn, ridged pyramidal horn, and corrugated conical horn and show the result that measured radiation characteristics.
After these antennas have been designed by means of the aperture field method or numerical solution and input the dimensions data to 3D printer and fabricated by laminating the resin.
Next these resin surfaces are coated with conductive paint and measured input impedance and radiation pattern, and we compare these results with the theoretical calculations.
We confirm that there is no problem in reflection characteristics by applying conductive paint on a flat same resin board, and measuring the reflectivity of the conductive paint which is attached to open side of waveguide.
The electrical performance of these fabricated resin antenna by 3D printer have almost no problem in comparison with the conventional produced antennas and we could show that it is cheap and short time for 3D printer to estimate small antenna. |
キーワード |
(和) |
3Dプリンター / 樹脂アンテナ / 開口面アンテナ / 角錐ホーン / ダブルリッジ角錐ホーン / コルゲート円錐ホーン / / |
(英) |
3D printer / resin antenna / aperture antenna / pyramidal horn / w-ridged pyramidal horn / corrugated conical horn / / |
文献情報 |
信学技報, vol. 114, no. 193, AP2014-72, pp. 1-6, 2014年8月. |
資料番号 |
AP2014-72 |
発行日 |
2014-08-21 (AP) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
AP2014-72 |