講演抄録/キーワード |
講演名 |
2012-03-01 10:20
[特別講演]特性調整機能付き増幅回路の設計 野地紘史・○福田 豪(東京理科大)・川崎繁男(JAXA) MW2011-169 エレソ技報アーカイブへのリンク:MW2011-169 |
抄録 |
(和) |
アンプコンテストは本業の研究課題と並行して作業するため,費やせる時間が限られていた.本来であれば,設計,回路作製(エッチング),測定・評価を数回繰り返し,特性を追い求めるが,今回はエッチングを一度で済ませ作業時間を短縮するために,回路作製後に調整可能な回路にした.その調整機能は,オープンスタブの先端や銅箔テープの使用によって得られる.また,発振防止として回路の動作安定性を高めるために,裏面のグランドと表面のグランドをビアで共通にした.加えてゲート側,ドレイン側のバイアスライン上に容量の異なるキャパシタをそれぞれ3つ並列配列した. |
(英) |
An amplifier with characteristics adjust functions was created with limited time to design the amplifier for the Student Contest of MWE2011 in necessity of other studies and researches. Normally the design and the fabrication are repeated to adjust circuit characteristics. For this study, it was applied to shorten fabrication time. The characteristic adjust functions was obtained at a tip of an open stub and using beaten-cupper tape. Further a ground of front side and back side was jointed with via holes to enhance operation stability. Additionally some capacitors were connected in parallel to prevent the circuit from oscillating. |
キーワード |
(和) |
L帯増幅器 / E-PHEMT / ラジアルスタブ / / / / / |
(英) |
L-Band Amplifier / E-PHEMT / Radial Stub / / / / / |
文献情報 |
信学技報, vol. 111, no. 458, MW2011-169, pp. 17-18, 2012年3月. |
資料番号 |
MW2011-169 |
発行日 |
2012-02-23 (MW) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
MW2011-169 エレソ技報アーカイブへのリンク:MW2011-169 |