講演抄録/キーワード |
講演名 |
2011-12-16 14:30
同軸管を用いた相互変調ひずみ測定に対する送信波整合状態の影響評価 ○齋藤健介・星野啓太・久我宣裕・石橋大二郎(横浜国大) EMD2011-109 エレソ技報アーカイブへのリンク:EMD2011-109 |
抄録 |
(和) |
本稿では,定在波同軸管を用いた高周波材料の相互変調ひずみ特性評価法について,送信波の整合状態と測定結果の関連に関する考察結果を報告している.提案する供試資料は容量結合された導体線二本という構成であり,2つの送信周波数に対してそれぞれ整合状態を実現できる点がこれまでと異なる.本報告では,まず始めに提案する試料構成における動作原理について線状導体を用いた考察結果を示す.その結果,二本の導体試料のうち,同軸管に対する結合端に近い試料の特性が支配的になることを確認している.また従来の試料を導体一本で構成する手法との比較を行い,現状の周波数条件では同程度の特性が得られることを確認している.さらに,実際の材料への適用例として,プリント基板の評価結果を示している.ここでは,周波数特性のばらつきを計算により補正した場合の結果も示し,その結果,入力特性によらない試料固有のPIMレベルを算出することが可能であることを確認している. |
(英) |
his report discusses an effect of matching condition on the passive intermodulation measurement using the standing-wave coaxial tube method.
In the proposed method, two conductive wires with capacitive coupling are used for a specimen to obtain impedance matching at transmitting frequencies.Firstly a specimen composed of wire-materials is employed to confirm the principle of the proposed method.The result shows that the material which is close to the coupling edge in the coaxial tube is dominant in this measurement.The proposed method shows almost equivalent sensitivity to the conventional method which uses a single conductive wire.Evaluation results of a printed circuit board are also presented as an example of a practical application.Intrinsic characteristics of the testing material are extracted by applying the calibration method proposed in the previous paper to this structure. |
キーワード |
(和) |
相互変調ひずみ / マイクロ波測定 / 非線形現象 / 基地局アンテナ / 同軸線路 / マイクロストリップ線路 / / |
(英) |
Passive intermodulation / Microwave measurements / Nonlinearity phenomena / basestation antenna / coaxial line / Microstrip line / / |
文献情報 |
信学技報, vol. 111, no. 356, EMD2011-109, pp. 17-22, 2011年12月. |
資料番号 |
EMD2011-109 |
発行日 |
2011-12-09 (EMD) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMD2011-109 エレソ技報アーカイブへのリンク:EMD2011-109 |