講演抄録/キーワード |
講演名 |
2009-06-30 15:50
K帯第2次高調波低雑音Gunn diode発振器 ○川崎健吾・田中高行・相川正義(佐賀大) MW2009-28 エレソ技報アーカイブへのリンク:MW2009-28 |
抄録 |
(和) |
本論文では,ガンダイオード高調波発振器の低雑音化技術についてを報告する.本発振器の出力は第 2 次
高調波であり,スロットライン共振器とガンダイオード,ストリップ線路から構成される.本発振器は共振器を中心とした設計であり,スロットライン共振器中にガンダイオードを直接装荷し,共振器上の不連続な境界条件によって第2 次高調波を直接励振させ,さらにストリップライン出力回路によって所望の高調波信号を取り出す.本回路は,多層平面回路によって回路の簡易化と小型化も同時に図っている.ここでは共振器の形状に不連続を設ける,即ち,発振器を従来の円形から方形状に変えたところ,位相雑音特性並びに不要波抑圧に特性の改善が見られた. |
(英) |
This paper presents a design method of low noise Gunn diode second harmonic oscillator. The oscillator consists of slot line resonators, Gunn diodes, and strip lines. A design of the oscillator is based on the active resonator. Gunn diodes are loaded on the slot line resonator and short-circuit boundary conditions are formed on both ends of the resonator. The second harmonic signal is directly generated on the resonator. Using the strip line output circuit, desired second harmonic signal is selectively obtained. As an additional discontinues boundary condition on the resonator is formed, the phase noise and the suppression of undesired harmonics are effectively
improved. |
キーワード |
(和) |
高調波発振器 / K-帯 / マイクロ波発振器 / 両平面回路 / / / / |
(英) |
Harmonic oscillator / K-band / Microwave oscillator / Double-sided MIC / / / / |
文献情報 |
信学技報, vol. 109, no. 109, MW2009-28, pp. 51-55, 2009年6月. |
資料番号 |
MW2009-28 |
発行日 |
2009-06-23 (MW) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
MW2009-28 エレソ技報アーカイブへのリンク:MW2009-28 |