講演抄録/キーワード |
講演名 |
2007-01-18 10:35
60GHz帯NRDガイドパルスレーダを用いたレベルセンサシング信号処理部における連続サンプリングによる測定精度の向上 ○出穂剛史・黒木太司(呉高専)・米山 務(東北工大) エレソ技報アーカイブへのリンク:ED2006-214 MW2006-167 |
抄録 |
(和) |
ミリ波レベルセンサ用レーダシステムとして、NRDガイドを用いたパルスレーダフロントエンドが試作され、測距実験が行われたがアンテナの指向性が鋭いためにアンテナと測定対象物との間で多重反射が発生し、レーダと測定対象物との距離が短い場合、正確な距離計算ができないという問題が生じた。そこでこのような多重反射の影響を除去するため、FPGAを使用した信号処理部を工夫し、多重反射の環境下においても、2mから20mまでの距離において測定誤差を12cm以下に抑えることができた。また、レーダシステムの測定精度を高めるために連続サンプリング方式を採用し、その有効性を確認した。 |
(英) |
A pulse radar front-end using an NRD-guide technology was fabricated for a millimeter wave level sensor, and then range finding was performed by using it. Multi-reflection however occurred between a target and a planar antenna due to a pencil beam radiation of our developing planar antenna, so that a precise distance could not be calculated for short range detection. In this paper, an FPGA-based signal processor was devised in order to eliminate such multi-reflection. Continuous sampling method was employed to reduce experimental errors, which were investigated from the viewpoint of difference of a period between a modulated pulse train and a continuous sampling clock. The error of range finding was successfully measured to be less than 12 cm for the distance range from 2 m to 20 m under the multi-reflection environment. It was improved compared with that of a signal processor without the continuous sampling method. |
キーワード |
(和) |
レーダ / FPGA / DSP / 連続サンプリング / / / / |
(英) |
radar / FPGA / DSP / sequential sampling / / / / |
文献情報 |
信学技報, vol. 106, no. 460, MW2006-167, pp. 79-82, 2007年1月. |
資料番号 |
MW2006-167 |
発行日 |
2007-01-10 (ED, MW) |
ISSN |
Print edition: ISSN 0913-5685 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
エレソ技報アーカイブへのリンク:ED2006-214 MW2006-167 |