講演抄録/キーワード |
講演名 |
2016-07-21 13:00
PTFE充填導波管による180GHz帯E面2分配器とホーンアンテナの試作評価 ○岸原充佳(岡山県立大)・山口明啓・内海裕一・太田 勲(兵庫県立大) AP2016-47 |
抄録 |
(和) |
放射光エッチングによりPTFEの直接加工を行い,表面に金属を蒸着させることで導波管を形成するプロセスが報告されている.本論文では,180GHz帯PTFE充填導波管でE面2分配器を一体化したホーンアンテナを試作している.E面2分配器を中心周波数180 GHzで設計し,開口幅1.40mmのE面ホーンをE面内に2個配置した回路形状を放射光エッチングプロセスにより試作し,180GHzにおけるE面およびH面放射パターンの測定結果を示している.測定結果は,HFSSと比較して大よそ一致していることを示している. |
(英) |
The fabrication process of the waveguide using the SR (synchrotron radiation) direct etching process of PTFE and the sputter deposition of metal has been reported. In this paper, a trial fabrication of E-plane horn antennas integrated with an E-plane 2-way power divider is performed based on the 180 GHz-band PTFE-filled waveguide. The E-plane 2-way divider designed at 180 GHz and the two E-plane horn antennas with aperture width of 1.40mm are arranged in the E-plane, then the circuit pattern is fabricated by the SR direct etching process. The E-plane and H-plane radiation patterns are measured at 180 GHz. The measured results are compared with the results of HFSS, and it is shown that the both results are in agreement. |
キーワード |
(和) |
X線リソグラフィ / 導波管コンポーネント / E面電力分配器 / E面ホーンアンテナ / / / / |
(英) |
X-ray lithography / waveguide components / E-plane power divider / E-plane horn antenna / / / / |
文献情報 |
信学技報, vol. 116, no. 142, AP2016-47, pp. 61-66, 2016年7月. |
資料番号 |
AP2016-47 |
発行日 |
2016-07-13 (AP) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
AP2016-47 |